Let me lay out the background for this project. Scooter is anattorney. Maybe that makes him a yuppie, who the fuck cares? He’s acriminal attorney of the highest order, in fact recently herepresented a prostitute and we will have a full report on thatepisode. In this case, he was representing a jealous Bouncer from a […]
Scooter’s Softail Custom Project Bike Read More »
Sponsored By Once the engine was back in place, the bolts were placed and the tape was removed. Then it was on to the area where the transmission was to be placed. The transmission plate from Custom Chrome and the rear fender mounts were put into place and bolted down. The transmission was
Digital’s Rigid – Part IV (Continued 3) Read More »
Sponsored By At this point I needed to make sure the front and rear pulleys were even at their outer edges. This was to make sure the belt does not rub on the pulley rim. A long level or other straight edge can be used to do this. If you need to move the front
Digital’s Rigid – Part IV (Continued 5) Read More »
We’ve collected a number of parts for the rigid over the last few months – but one key item was missing. That’sthe engine. When it came time to decide on a power plant for the project, there were a couple of factors thatwarrented consideration. The first is of course, cold hard cash. None of us
Digital’s Rigid – Part II Read More »
Sponsored By It was then time to put the Revtech engine in place. Caution and ease are the keys to success here. One thing to note: If you build a ride of your own and are using the type of stand I do, which sits under the frame, make sure the rails are around where
Digital’s Rigid – Part IV (Continued) Read More »
Sponsored By This project uses a BDL open drive system to drive the tranny, so the motor plate was put into place and bolted down while the engine bolts and transmission bolts were still loose. Make sure to use Loctite 242 and to torque the bolts to spec per the instruction sheet provided with the
Digital’s Rigid – Part IV (Continued 4) Read More »
Sponsored By Now here’s the test. If you’ve been paying attention, you’ll notice that I DIDN’T put on the secondary belt before we put on the motor plate! Just remember to do this and save yourself the removal of the assembly to fix this mistake. With everything in place, I put the friction plate back
Digital’s Rigid – Part IV (Continued 6) Read More »
Sponsored By Once the tape was removed, a small Dremel tool was used to strip the area down to the bare metal. The area was cleaned and the engine was placed back in the frame over the bare metal spots. On to Part 4, Page 4…. Back to Part 4, Page 2….
Digital’s Rigid – Part IV (Continued 2) Read More »
Sponsored By Although you haven’t seen it in a fully assembled state, the rigid has actually been mocked up to completion. However, anyone who’s built their own sled knows that an assembled bike without paint and powder just isn’t quite the same as the finished product. Although a primered mock-up will show you the lines
Digital’s Rigid – Part IV Read More »
OK, I know….. It’s a shitty photo. Sorry folks. The good news is, it’s promted me to goout and buy a new camera – so keep an eye out for some high quality photography in the nextinstallment. So here it is. Actually, as I write this, the project is a little further than the photowould
Digital’s Rigid – Part III Read More »
