Sponsored By It was then time to put the Revtech engine in place. Caution and ease are the keys to success here. One thing to note: If you build a ride of your own and are using the type of stand I do, which sits under the frame, make sure the rails are around where […]
Digital’s Rigid – Part IV (Continued) Read More »
Sponsored By This project uses a BDL open drive system to drive the tranny, so the motor plate was put into place and bolted down while the engine bolts and transmission bolts were still loose. Make sure to use Loctite 242 and to torque the bolts to spec per the instruction sheet provided with the
Digital’s Rigid – Part IV (Continued 4) Read More »
Sponsored By Now here’s the test. If you’ve been paying attention, you’ll notice that I DIDN’T put on the secondary belt before we put on the motor plate! Just remember to do this and save yourself the removal of the assembly to fix this mistake. With everything in place, I put the friction plate back
Digital’s Rigid – Part IV (Continued 6) Read More »
Sponsored By Once the tape was removed, a small Dremel tool was used to strip the area down to the bare metal. The area was cleaned and the engine was placed back in the frame over the bare metal spots. On to Part 4, Page 4…. Back to Part 4, Page 2….
Digital’s Rigid – Part IV (Continued 2) Read More »
Sponsored By Although you haven’t seen it in a fully assembled state, the rigid has actually been mocked up to completion. However, anyone who’s built their own sled knows that an assembled bike without paint and powder just isn’t quite the same as the finished product. Although a primered mock-up will show you the lines
Digital’s Rigid – Part IV Read More »
OK, I know….. It’s a shitty photo. Sorry folks. The good news is, it’s promted me to goout and buy a new camera – so keep an eye out for some high quality photography in the nextinstallment. So here it is. Actually, as I write this, the project is a little further than the photowould
Digital’s Rigid – Part III Read More »
The above photo details the back end of the Atlas Precision ‘Roadrunner’ frame. Attached is a 9″ wide stubby fender, also supplied by Atlas. Both the fender and the frame are designed to handle 200 mm meat. We’ll be using a 180 for the project. Since wide tire aftermarket frames require special fenders, you have
Digital’s Rigid 2001 Part 1 (Continued) Read More »
THE GUNNY INVESTIGATION–TRAINING AND TOUGHER LAWS THE AIM/NCOM MOTORCYCLE E-NEWS SERVICE is brought to you by Aid to Injured Motorcyclists (A.I.M.) and the National Coalition of Motorcyclists (NCOM), and is sponsored by the Law Offices of Richard M. Lester. For more information, call us at 1-(800) ON-A-BIKE or visit us on our website at http://www.ON-A-BIKE.com.From
December 21, 2003 Read More »
THE BISH INVESTIGATION–MOVIES, RESTAURANTS AND LEGAL WRANGLING Bill Bish author and freedom fighter.THE AIM/NCOM MOTORCYCLE E-NEWS SERVICE is brought to you by Aid to Injured Motorcyclists (A.I.M.) and the National Coalition of Motorcyclists (NCOM), and is sponsored by the Law Offices of Richard M. Lester. For more information, call us at 1-(800) ON-A-BIKE or visit
December 17, 2003 Read More »
GUNNY SACK TEARS AT THE NHSTA, COPS IN SAN FRAN, WOMAN RIDES TO BASE CAMP AND MORE The famous Gunny.THE AIM/NCOM MOTORCYCLE E-NEWS SERVICE is brought to you by Aid to Injured Motorcyclists (A.I.M.) and the National Coalition of Motorcyclists (NCOM), and is sponsored by the Law Offices of Richard M. Lester. For more information,
November 20, 2003 Read More »
