This kit is easy to use, easy to wire and a boat load of fun! When Rivera-Primo came out with the Mini & Mighty Magnum™ HedLED™ Headlights in 2008, they never thought that they would turn out to be as big a hit as they have. The integral LED turn signals are trick, cosmetically […]
You Need A Good Solid State Controler To Run LED Turn Signals Read More »
Over the past three years our team at Biker Pros has produced over 35 custom bike shows. We seen 1000+ custom bikes from Los Angles to Daytona, and we noticed a major critical custom bike element, the wheels. Over and over a dominating competitive factor in a custom show are wheels and one brand consistently
RIDEWRIGHT WHEELS KEEPS CUSTOM BIKES ROLLING Read More »
I started off intent on just check the cam chain tensioners on my 2009 FLHTC, and then thought, what the hell. As long as it’s apart, I might as well upgrade to the Zipper’s Red Shift 525-HS cams. The 525-HS cams are a set of bolt-in units, and they allow me to use my
ZIPPER’S RED SHIFT 525 CAM INSTALL Read More »
Editor’s Note: Mike McGuire is a tech chatter in the Destination Daytona SuperStore. He’s been with J&P since December 2010, where he started as a phone tech. A Harley-Davidson tech, Mike has a master of chassis certification from Harley-Davidson. Originally from Michigan, he graduated cum laude from Walsh College in Michigan, where he received his
New Pipes? Are You Getting Everything You Wanted? Read More »
Well it’s that time! Now that Daron Ray of Hazzardous Customs is finished striping the tins to bare metal and finishing them with 1964 Highland Green from the Ford Motor Company (House of Kolor match), I can finally get the old girl back on the road. I figured as long as I had the bike
Tail Gunner’s New Paint Job Read More »
If you are thinking about upgrading the cams in your Twin Cam Harley or even if you are just taking it apart to service and or replace the chain tensioners, it is highly recommended that you change the factory bearing with a set of new Torrington bearings. The simple reason contains reliability and strength factors.
Installing New Upgraded Cam Bearings In A Twin Cam Read More »
This is an interesting one. We met Paul Morris at the Long Beach Ultimate Builder Competition December 7th to the 9th. Our own Ray C. Wheeler competed against Paul in the Performance category. “Ray’s bike had it hands down,” Paul said. But Ray’s bike wasn’t completed so we had to take him out of the
G2 Gangster-Street Legal Street Pro Bike Read More »
Here’s the link to Mudflap Girl Part 11: http://www.bikernet.com/pages/Mudflap_Girl_FXRs_part_11_The_First_Road_Test.aspx My son’s Mudflap Girl FXR is running and partially broken in. I even, finally, dialed in the Wire Plus Speedometer, and it’s working. I wish I knew what I was doing wrong, but that puppy works like a champ. I enjoy the tightness of the display
Mudflap Girl FXR Part 12—She meets S&S Read More »
We have a goofy Shovelhead in the Bikernet shop called the 1928 Shovelhead. It has 21-inch wheels front and rear in a Paughco rigid frame, but some 1928 elements were used, including the re-pop semi-flat sided tanks, the rear fender and perhaps the seat. The bike was conceived by Bandit the bastard, built by the
Rivera-Primo Brute II Install Read More »
Tail Gunner checking in! Well it’s winter again, so I thought I’d give my old Softail a face lift. She’s been a good old gal, a survivor of many a road trip. But the years are starting to show, paint chips, fading and rock dings everywhere, plus the old pin stripping is looking a little
Tail Gunner Makes Time for a Face Lift Read More »
